Siemens SINUMERIK 840Di Diagnostic Manual page 499

11/2006
61104 Channel %1 block %2: Contour violation of grooves
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Incorrect parameterization of the milling pattern in the parameters which define the position of the
slots/elongated holes on the circle and their form. Alarm triggered by following cycles: SLOT1, SLOT2,
LONGHOLE.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: --
Program Clear alarm with the RESET key. Restart part program
Continuation:
61105 Channel %1 block %2: Milling cutter radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The diameter of the cutter used is too large for the form to be machined. Alarm triggered by following
cycles: SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE, CYCLE90.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Either a tool with a smaller radius has to be used or the contour must be modified.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61106 Channel %1 block %2: Number of or distance between circular elements
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Incorrect parameterization of NUM or INDA. The layout of the circle elements within a full circle is not
possible. Alarm triggered by following cycles: HOLES2, LONGHOLE, SLOT1, SLOT2.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Correct parameterization.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61107 Channel %1 block %2: First drilling depth incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: First drilling depth is in the opposite direction to the total drilling depth. Alarm triggered by following
cycle: CYCLE83.
Reaction: Alarm display.
Interface signals are set.
NC Start disable in this channel.
Interpreter stop
Remedy: Modify drilling depth.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-499