Siemens SINUMERIK 840Di Diagnostic Manual page 648

Overview of Alarms
HMI alarms
105003 Workpiece %1 exists already
Parameters: %1 = --
Definitions: The workpiece name entered is already in this directory.
Remedy: --
105004 Paste buffer is empty! First COPY then PASTE
Definitions: No file could be inserted, as no file was copied to the clipboard.
Remedy: --
105005 Only tools can be inserted here
Definitions: The file type of the previously copied file is not _wpd and cannot be inserted into
the workpiece directory.
Remedy: --
105006 Only files can be inserted here
Definitions: A file of the file type _wpd, i.e. a workpiece, was copied from the workpiece directory and an attempt
was made to insert it into a program directory.
Remedy: --
105007 No name entered
Definitions: --
Remedy: Wait until the loading procedure is terminated.
105008 Write memory error on cycle call
Definitions: The resources of the MMC100 are exhausted.
No more dynamic memory available.
Remedy: --
105009 No write access to data
Definitions: The file is write-protected.
Remedy: --
105010 No data selected
Definitions: The cursor is not placed on a valid file name.
Remedy: --
105011 Cycles overview %1 not available
Parameters: %1 = --
Definitions: The cycle description sc.com was not found in the NCK file system.
Remedy: --
105012 Program not or only partially editable (NC Reset)
Definitions: The selected program is currently being executed.
Remedy: --
105013 Copied data can be inserted with SK 'Paste'
Definitions: The copied data is in the clipboard and can be inserted anywhere via the softkey "Paste".
Remedy: --
2-648
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006