Siemens SINUMERIK 840Di Diagnostic Manual page 515

11/2006
61204 Channel %1 block %2: Technology cycle unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified technology cycle in the machining block is unknown.
Alarm triggered by following cycles: E_MANAGE, F_MANAGE.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Delete and reprogram the technology block.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61205 Channel %1 block %2: Position cycle unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified positioning cycle in the machining block is unknown.
Alarm triggered by following cycles: E_MANAGE, F_MANAGE.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Delete and reprogram the positioning block.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61210 Channel %1 block %2: Block search element not found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The element specified for the block search does not exisit.
Alarm triggered by following cycles: E_MANAGE, E_PS_CIR, E_PS_MRX, E_PS_POL, E_PS_SEQ,
E_PS_XYA, F_MANAGE, F_PS_CIR, F_PS_MRX, F_PS_SEQ
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Repeat block search.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61211 Channel %1 block %2: Absolute reference missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An incremental indication was made, but the absolute reference is unknown.
Alarm triggered by following cycles: E_MI_CON, E_MI_PL, E_PI_CIR, E_PI_REC, E_PO_CIR,
E_PO_REC, E_PS_CIR, E_PS_HIN, E_PS_MRX, E_PS_POL, E_PS_SEQ, E_PS_XYA, E_SL_CIR,
E_SL_LON, F_PS_CIR, F_PS_MRX, F_PS_SEQ
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program an absolute position prior to using incremental indications.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-515