NEC ASPILA EX Feature Manual page 358

Programming
344 Features
•10-09-01 : DTMF and Dial Tone Circuit Setup
If the system has DTMF tie lines, be sure to reserve at least one circuit for analogue trunk
DTMF reception (type 0 or 2).
• Use the following as a guide when allocating DTMF receivers:
- In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
- In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
•14-01-02 : Basic Trunk Data Setup - Transmit CODEC Gain Type
14-01-03 : Basic Trunk Data Setup - Receive CODEC Gain Type
Customize the transmit and receive levels of the CODEC Gain Types for each trunk as
required.
•14-01-13 : Basic Trunk Data Setup - Loop Disconnect Supervision
Enable (1) loop supervision for each tie line that should be able to place outgoing calls.
•14-02-01 : Analogue Trunk Data Setup - Signaling Type (DP/DTMF)
Set the outgoing signaling type for the tie trunk. The options are 0 (DP 10 pps), 1 (DP 20 pps)
and 2 (DTMF). To set incoming signaling, refer to Program 34-01-02.
•14-05-01 : Trunk Groups
Program tie lines of similar type into the same trunk group (1-100). The system uses trunk
groups for outgoing access to tie lines (i.e., Service Code 804 + group). Also see Program 34-
05.
•14-06-01 : Trunk Group Routing
When a tie line user dials 9, the system uses the routes defined in this program (1-100). Also
see Program 34-03. (If the system has ARS, the tie line user accesses ARS when they dial 9.)
•20-01-01 : System Options - DTMF Receiver Active Time
After answering the tie line call, the system attaches a DTMF receiver to the tie line for this
interval (0- 64800 seconds).
•20-09-01 : Class of Service Options (Incoming Call Service) - Second Call for DID/ DISA/
DIL/ E&M
Enable (1) or disable (0) an extension's ability to receive a second call from a DID, DISA,
DIL, or tie line caller.
•20-14-01 : Class of Service Options for DISA/E&M
Enable (1) or disable (0) the following options for each tie line Class of Service (1-15):
• First Digit Absorption (Item 1)
• Trunk Group Routing/ARS Access (Item 2)
• Direct Trunk Access (Item 3)
• Common Abbreviated Dialing (Item 4)
• Operator Calling (Item 5)
• Internal Paging (Item 6)
• External Paging (Item 7)
• Direct Trunk Access (Item 8)
• Forced Trunk Disconnect (Item 9)
• Call Forward Setting by Remote Via DISA (Item 10)
• DISA/Tie Trunk Barge In (Item 11)
•22-02-01 : Incoming Call Trunk Setup
For each Night Service mode, enter service type 5 when the trunk should be a tie trunk.
•34-01-01 : E&M Tie Line Basic Setup - DID/E&M Start Signaling
Enter 0 for 2nd dial tone, 1 for wink, 2 for immediate, or 3 for delay start signaling. To set
outgoing signaling, refer to Program 14-02-01.
•34-02-01 : E&M Tie Line Class of Service
Assign the tie line's Class of Service (1-15). Use Program 20-14 to set the tie line Class of
Tie Lines
Aspila EX Software Manual