NEC ASPILA EX Feature Manual page 416

Introduction to Programming
Before You Start Programming
Using Keys to Move Around in the Programs
Use this key...
0-9, * and #
HOLD
CONF
MSG
FLASH
LINE KEYS
LINE KEY 1
LINE KEY 2
LINE KEY 3
VOL UP
VOL DOWN
410 Programming
Once you enter the programming mode, use the keys in the following chart to enter data, edit data
and move around in the menus.
Keys for Entering Data
Enter data into a program.
Complete the programming step you just made (like pressing Enter on a PC
keyboard). When a program entry displays, press HOLD to bypass the entry
without changing it.
Delete the entry to the left (like pressing Backspace on a PC keyboard).
Exit one step at a time from the program window currently being viewed.
For example, if you're programming item 5 in 15-03, pressing MSG will
allow you to enter a new option in program 15-03. Pressing MSG again will
allow you to select a new program in the 15- series. Pressing MSG a third
time will allow you to enter a new program beginning with '1'. Pressing
MSG one last time will bring you to the beginning program display, allow-
ing you to enter any program number.
Switch extension, line, etc. being programmed by pressing FLASH. The
cursor moves up to the top row of the display. Pressing FLASH again moves
the cursor back to the middle row.
Use pre-programmed settings to help with the program entry. These settings
vary between programs from LINE 1 = 0 (off) and LINE 2 = 1 (on) to preset
values for timers where LINE 1 = 5, LINE 2 = 10, LINE 3 = 15, etc.
For programs with this option, the line key which currently matches the pro-
grammed setting will light steady.
The display may also indicate Soft Keys which will allow you to select the
values as well (-1 and +1 will step through these pre-programmed settings.)
Program a pause into an Abbreviated Dialing bin.
Program a recall/flash into an Abbreviated Dialing bin.
Program a @ into an Abbreviated Dialing bin.
Scroll backward through a list of entry numbers (e.g., from extension 200 to
201, 203, etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data before
scrolling forward.
Scroll forward through a list of entry numbers (e.g., from extension 200 to
201, 203, etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data before
scrolling backward
When you want to . . .
Aspila EX Software Manual