Mitsubishi Electric MELSERVO-J2-Super Series Instruction Manual page 190

6. PARAMETERS
Class No. Symbol
Software limit
48 LMN
Used to set the address decrement side software stroke limit. The software limit
49
is made invalid if this value is the same as in "software limit ".
(Refer to Section 6.2.8)
Set the same sign to parameters No.48 and 49. Setting of different signs will
result in a parameter error.
Position range output address
50 *LPP
Used to set the address increment side position range output address. Set the
51
same sign to parameters No.50 and 51. Setting of different signs will result in a
parameter error.
In parameters No. 50 to 53, set the range where position range (RXnE) turns on.
(Refer to Section 4.3.2 (1)(c))
Position range output address
52 *LNP
Used to set the address decrement side position range output address. Set the
53
same sign to parameters No.52 and 53. Setting of different signs will result in a
parameter error.
54 For manufacturer setting
Don't change this value by any means.
55 *OP6 Function selection 6
Used to select how to process the base circuit when reset (RES) is valid.
0
56 For manufacturer setting
Don't change this value by any means.
57 *OP8 Function selection 8
Used to select the protocol of serial communication.
0
Name and Function
Set address:
Upper 3
digits
Set address:
Upper 3
digits
Set address:
Upper 3
digits
0 0
Processing of the base circuit when reset (RES) is valid.
0: Base circuit switched off
1: Base circuit not switched off
0 0
Protocol checksum selection
0: With station numbers
1: No station numbers
Lower 3
digits
Parameter No. 49
Parameter No. 48
Lower 3
digits
Parameter No. 51
Parameter No. 50
Lower 3
digits
Parameter No. 53
Parameter No. 52
6 - 13
Initial Setting
Unit
value range
0 10 999999
STM
m
to
999999
0 10 999999
STM
m to
999999
0 10 999999
STM
m
to
999999
0000
0100
Refer to
Name
and
function
column.
0000
0000
Refer to
Name
and
function
column.