Display And Operation; Display Flowchart - Mitsubishi Electric MELSERVO-J2-Super Series Instruction Manual

8. DISPLAY AND OPERATION

8. DISPLAY AND OPERATION

8.1 Display flowchart

Use the display (5-digit, 7-segment LED) on the front panel of the servo amplifier for status display,
parameter setting, etc. Set the parameters before operation, diagnose an alarm, confirm external
sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move
to the next screen. Refer to Section 8.2 and later for the description of the corresponding display mode.
To refer to or set the expansion parameters 1, expansion parameters 2, special parameters 1, special
parameters 2 and option unit parameter make them valid with parameter No.19 (parameter write
disable).
Display mode transition
Status display
Diagnosis
Alarm
Point table
Basic parameter
button
MODE
Expansion parameter 1
Expansion parameter 2
Special parameter 1
Special parameter 2
Option unit parameter
Initial screen
Servo status display.
Alarm display, external signal display, output
signal (DO) forced output, test operation,
software version display, VC automatic offset,
motor series ID display, motor type ID display,
encoder ID display
Current alarm display, alarm history display,
parameter error No. display, point table error
No. display.
Display and setting of point table data.
Display and setting of basic parameters.
Display and setting of expansion parameters 1.
Display and setting of expansion parameters 2.
Display and setting of special parameters 1.
Display and setting of special parameters 2.
Display and setting of option unit parameter.
8 - 1
Function
appears at power-on.
Reference
Section 8.2
Section 8.3
Section 8.4
Section 8.5
Section 8.6