Table of Contents
Advertisement
Safety statements
CAUTION:
Do not install a unit in a rack where the internal rack ambient temperatures will
•
exceed the manufacturer's recommended ambient temperature for all your rack-
mounted devices.
Do not install a unit in a rack where the air flow is compromised. Ensure that air
•
flow is not blocked or reduced on any side, front, or back of a unit used for air flow
through the unit.
Consideration should be given to the connection of the equipment to the supply
•
circuit so that overloading of the circuits does not compromise the supply wiring or
over-current protection. To provide the correct power connection to a rack, refer to
the rating labels located on the equipment in the rack to determine the total
power requirement of the supply circuit.
(For sliding drawers)
•
stabilizer brackets are not attached to the rack. Do not pull out more than one
drawer at a time. The rack might become unstable if you pull out more than one
drawer at a time.
(For fixed drawers)
•
servicing unless specified by the manufacturer. Attempting to move the drawer
partially or completely out of the rack might cause the rack to become unstable or
cause the drawer to fall out of the rack.
(R001 part 2 of 2)
Rack Safety Information, Statement 3
Always lower the levelling pads on the rack cabinet.
•
Always install stabilizer brackets on the rack cabinet.
•
Always install servers and optional devices starting from the bottom of the rack
•
cabinet.
Always install the heaviest devices in the bottom of the rack cabinet.
•
xviii
Do not pull out or install any drawer or feature if the rack
This drawer is a fixed drawer and must not be moved for
6U Rack or Tower UPS RT8kVA and RT11kVA IUOMG
Advertisement
Table of Contents
