Table of Contents
Advertisement
Chapter 3 Overview
Shipping bracket kit
If you are shipping the UPS and its associated Extended Battery Modules or EBMs pre-
installed in a rack, you must use the shipping bracket kit to prevent damage during shipment.
The kit is available from Lenovo. Refer to the instructions in the kit to install the brackets
properly. The brackets are not required when the UPS and EBMs are installed in a pre-
positioned rack.
Rear panels
6U Rack or Tower UPS RT8kVA and RT11kVA IUOMG
RS232 communication port
USB communication port
Dry (relay) contacts communication
port
Connector for Remote On/Off (ROO)
control
Connectors for automatic recognition
of battery module
Connector for Remote Power Off
(RPO) control
Slot where UPS Network Management
Card is installed
Connector for battery module power
Terminal blocks for AC power input
and output
Connector for HotSwap MBP detection
Connectors for battery modules (to the
UPS or to the other battery modules)
Connectors for automatic recognition of
battery modules (UPS-to-EBM or EBM-
to-EBM)
Battery circuit breaker
11
Advertisement
Table of Contents
