Table of Contents
Advertisement
Chapter 5 Installation
Chapter 5 Installation
Please review
DO NOT store the UPS unit or any Extended Battery Modules for longer than 6 (six) months!
If the UPS unit or any Extended Battery Modules are stored for longer than 6 months then it
could be that the UPS will not power up after installing it. For additional information see
may fail when installed after longer storage time
Inspecting the equipment
If any equipment has been damaged during shipment, keep the shipping cartons and packing
materials and contact your place of purchase.
Note: Check the battery recharge date on the shipping carton label. If the date has passed and the
battery packs were never recharged, do not use the UPS. Contact your service representative.
Unpacking the unit
Important: Unpacking the unit in a low-temperature environment might cause condensation to occur
in and on the unit. Do not install the unit until the inside and outside of the unit are
absolutely dry (hazard of electric shock).
Step 1. Unpack the equipment and remove all packing materials and the shipping carton.
Important: Do not lift the UPS or EBM from the front panel.
Attention! When unpacking and installing the UPS unit's power module, pay attention to any
connectors on the back side of the UPS unit such as RPO, ROO, serial connectors etc.
Make sure that these are not damaged!
See
illustration on the following page
42
Chapter 4
before commencing with the UPS installation!
.
in
Chapter
11.
6U Rack or Tower UPS RT8kVA and RT11kVA IUOMG
UPS
Advertisement
Table of Contents
