Table of Contents
Advertisement
Chapter 5 Installation
The device can be installed anywhere on the rack by using either the screws or the self-
adhesive hook-and-loop fasteners. Once attached to the rack, connect the CAT5 cable to the
UPS or a supported PDU Ethernet connector.
Note: The installation of a Network Management Card (NMC) is required for the EMP to be connected
to the device. Refer to the
information on the NMC.
Views of the EMP
The following figure shows the EMP installed at the top of a rack using the adhesive tape that
comes with the device. An Ethernet cable runs back into the rack to a monitored PDU or UPS.
6U Rack or Tower UPS RT8kVA and RT11kVA IUOMG
Network Management Card (NMC)
section for additional
69
Advertisement
Table of Contents
