D-Link DWS-4026 User Manual page 114

D-Link Unified Access System
Field
LACP Mode
Physical Mode
Physical Status
Link Status
Link Trap
• Click Refresh to display the most current information from the router.
Page 114 Port Summary
Table 44: Port Summary Fields (Cont.)
Description
Indicates the Link Aggregation Control Protocol administration state. The mode must
be enabled in order for the port to participate in Link Aggregation. This field can have
the following values:
• Enable: Specifies that the port is allowed to participate in a port channel (LAG), which
is the default mode.
• Disable: Specifies that the port cannot participate in a port channel (LAG).
Shows the speed and duplex mode at which the port is configured:
• Auto: The duplex mode and speed will be set by the auto-negotiation process. The
port's maximum capability (full duplex and 100 Mbps) will be advertised.
• <Speed> Half Duplex: The port speeds available from the menu depend on the
platform on which the D-Link software is running and which port you select. In half-
duplex mode, the transmissions are one-way. In other words, the port does not send
and receive traffic at the same time.
• <Speed> Full Duplex: The port speeds available from the menu depend on the
platform on which the D-Link software is running and which port you select. In half-
duplex mode, the transmissions are two-way. In other words, the port can send and
receive traffic at the same time.
Indicates the port speed and duplex mode at which the port is operating.
Indicates whether the Link is up or down.
This object determines whether or not to send a trap when link status changes. The
factory default is enabled.
• Enable: Specifies that the system sends a trap when the link status changes.
• Disable: Specifies that the system does not send a trap when the link status changes.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09