Mac Access Control Lists; Mac Acl Configuration; Figure 245: Mac Acl Configuration - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Deleting a Rule from an IP-based ACL
1 Open the IP ACL Rule Configuration page.
2 Select the desired ACL from the IP ACL menu.
3 Select the rule to delete from the Rule field.
4 Click Delete.
The new rule is assigned to the specified IP-based ACL.
5 Click Refresh to update the page with the most current information.
MAC A C
CCESS ONTROL
A MAC ACL consists of a set of rules which are matched sequentially against a packet. When a packet meets the match
criteria of a rule, the specified rule action (Permit/Deny) is taken and the additional rules are not checked for a match. On
this menu the interfaces to which an MAC ACL applies must be specified. Rules for the MAC ACL are specified/created using
the MAC ACL Rule Configuration menu.
This folder links to the following pages:
•

"MAC ACL Configuration"

• "MAC ACL Rule Configuration"
First, you use the "MAC ACL Configuration"
ACL Rule Configuration"
ACL by its ID number to a port or VLAN.
MAC ACL Configuration
The MAC ACL Configuration page allows network administrators to define a MAC-based ACL. For an explanation of ACLs,
see ""IP Access Control Lists"
To display the MAC ACL Configuration page, click LAN > QoS > Access Control Lists > MAC Access Control Lists >
Configuration in the navigation tree.
Document 34CSFP6XXUWS-SWUM100-D7
L
ISTS
page to define the ACL type and assign an ID to it. Then, you use the
page to create rules for the ACL. Finally, you use the
."

Figure 245: MAC ACL Configuration

D-Link Unified Access System
"ACL Interface Configuration"
Configuring Access Control Lists
"MAC
to assign the
Page 351