D-Link Unified Access System
V
A
P
ALID
CCESS
OINT
The Wireless Global Configuration page contains a field to select whether to use a local or RADIUS database for AP
Validation. The Valid Access Point Summary page contains information about APs configured in the local database. If the
AP Validation is set to RADIUS, information about the APs to be managed by the switch must be added to the external
RADIUS database.
You can add an AP into the local list of Valid APs from the WLAN > Administration > Basic Setup > Valid AP tab, as the
following figure shows, or you can add an AP from the AP Authentication Failures or Rogue AP/RF Scan lists.
Field
AP Database
Managed AP
Rogue AP
Standalone AP
MAC Address
Location
AP Mode
Page 436
Basic Setup
S
UMMARY
Figure 300: Adding a Valid AP
Table 266: Valid Access Point Summary
Description
Identifies the total number of APs that have been added to the AP database.
Identifies the number of APs in the database with an AP Mode set to Managed.
Identifies the number of APs in the database with an AP Mode set to Rogue.
Identifies the number of APs in the database with an AP Mode set to Standalone.
Enter the MAC address of the AP in this field. When you add the MAC address, you add the
AP to the local database on the switch.
Enter a location to help identify the AP. This field is optional and accepts up to 32
alphanumeric characters, including special characters.
This field displays the current mode of the AP, which can be one of the following:
• Managed
• Standalone
• Rogue
To configure a different mode, click the MAC address of the AP to go to the Valid Access Point
Configuration page.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09