D-Link DWS-4026 User Manual page 388

D-Link Unified Access System
Field
ControlMode
Start Period
Held Period
Authentication Period
Maximum Requests
Click Submit to configure the supplicant. Note that these changes will not be retained across a power cycle unless you
All Applied Changes.
Click Refresh to display the page with the latest data from the switch.
Page 388 Port Access Control
Table 245: Dot1x Supplicant Port Configuration
Description
Select the port authorization state. The control mode is set only if the link
status of the port is link up. The possible field values are:
Auto: The ports mode (Authorized, Unauthorized, etc.) is determined by
802.1X exchanges with supplicants and the authentication server.
Force Authorized: Places the interface into an authorized state without
being authenticated. The interface sends and receives normal traffic
without client port-based authentication.
Force Unauthorized: Denies the selected interface system access by
moving the interface into unauthorized state. The switch cannot provide
authentication services to supplicants through this interface.
Enter the wait interval period in seconds for the supplicant to receive the
authenticator's EAP Identity request message.
Enter the wait interval period in seconds for the supplicant to start the
next authentication process after a previous authentication process
failure.
Enter the wait interval period for the supplicant to receive EAP challenge
requests form the authenticator.
Enter the maximum number of successive EAPOL start messages that
will be sent before the supplicant assumes that there is no authenticator
present.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09
Save