D-Link DWS-4026 User Manual page 463

Software User Manual
12/10/09
Field
Location
Switch Port
IP Address
Software Version
Age
Status
Configuration Status
Profile
Radio
Channel
Authenticated Clients
You can sort the list of APs by clicking any of the column headings. For example, to sort the APs by the
profile they use, click Profile.
The Delete button clears an entry from the current list. You cannot delete the entry for an AP that is managed.
Document 34CSFP6XXUWS-SWUM100-D7
Table 282: Managed Access Point Status
Description
A location description for the AP. This is the value configured in the valid AP database (either
locally or on the RADIUS server).
The physical port (in the slot/port format) on the switch that the AP is connected to either
directly or indirectly in the same L3 domain. If the AP is beyond the L3 network boundary, then
'Unknown' is displayed.
The network IP address of the managed AP.
The software version the AP is currently running.
Time since last communication between the Unified Switch and the AP.
The current managed state of the AP. The possible values are:
• Discovered: The AP is discovered and by the switch, but is not yet authenticated.
• Authenticated: The AP has been validated and authenticated (if authentication is enabled),
but it is not configured.
• Managed: The AP profile configuration has been applied to the AP and it's operating in
managed mode.
• Failed: The Unified Switch lost contact with the AP, a failed entry will remain in the managed
AP database unless you remove it. Note that a managed AP will temporarily show a failed
status during a reset.
Note: When management connectivity is lost for a managed AP, then both radios of the AP
are turned down. All the clients associated with the AP get disassociated. The radios
become operational if and when that AP is managed again by a switch.
This status indicates if the AP is configured successfully with the assigned profile. The status
is one of the following:
• Not Configured: The profile has not been sent to the AP yet, the AP may be discovered but
not yet authenticated.
• In Progress: The switch is currently sending the AP profile configuration packet to the AP.
• Success: The entire profile has been sent to the AP and there were no configuration errors.
• Partial Success: The entire profile has been sent to the AP and there were configuration
errors (for example, some configuration parameters were not accepted), but the AP is
operational.
• Failure: The profile has been sent to the AP and there were configuration errors, the AP is
not operational.
The AP profile configuration currently applied to the managed AP. The profile is assigned to
the AP in the valid AP database.
Note: Once an AP is discovered and managed by the Unified Switch, if the profile is
changed in the valid AP database (either locally or on the RADIUS server) the AP must be
reset to configure with the new profile.
Shows the wireless radio mode that each radio on the AP is using.
Shows the operating channel for the radio.
Shows the number of wireless clients associated and authenticated with the access point per
radio.
D-Link Unified Access System
Monitoring Status and Statistics Page 463