Table of Contents
Advertisement
Software User Manual
12/10/09
Field
Description
Validate Source
Select the DAI Source MAC Validation Mode for the switch. If you select Enable, Sender MAC
MAC
validation for the ARP packets will be enabled. The default is Disable.
Validate
Select the DAI Destination MAC Validation Mode for the switch. If you select Enable, Destination
Destination MAC
MAC validation for the ARP Response packets will be enabled. The default is Disable.
Validate IP
Select the DAI IP Validation Mode for the switch. If you select Enable, IP Address validation for the
ARP packets will be enabled. The default is Disable.
•
Click Submit to apply the new configuration and cause the change to take effect. These changes will not be retained
across a power cycle unless a Save configuration is performed.
DAI VLAN C
ONFIGURATION
Use the DAI VLAN Configuration page to select the DAI-capable VLANs for which information is to be displayed or
configured.
To display the DAI Configuration page, click LAN > L2 Features > Dynamic ARP Inspection > DAI VLAN Configuration
in the navigation tree.
Field
Description
VLAN ID
Select the VLAN ID for which information is to be displayed or configured.
Dynamic ARP
Select whether Dynamic ARP Inspection is Enabled or Disabled on this VLAN. The default is
Inspection
Disable.
Logging Invalid
Select whether Dynamic ARP Inspection logging is Enabled or Disabled on this VLAN. The default
Packets
is Disable.
ARP ACL Name
The name of the ARP Access List. A VLAN can be configured to use this ARP ACL containing rules
as the filter for ARP packet validation. The name can contain 1-31 alphanumeric characters.
Document
34CSFP6XXUWS-SWUM100-D7
Table 113: Dynamic ARP Inspection Configuration
Figure 131: Dynamic ARP Inspection VLAN Configuration
Table 114: Dynamic ARP Inspection VLAN Configuration
D-Link Unified Access System
Configuring Dynamic ARP Inspection
Page 209
- Quick Links:
- Section 1: Getting Started
Hide quick links:
Advertisement
Table of Contents
