Configuring A Secondary Vrrp Address; Creating A New Virtual Router; Modifying A Virtual Router - D-Link DWS-4026 User Manual

D-Link Unified Access System
Field
IP Address
Authentication Type
Authentication Data
Status
• Click Submit to apply the new configuration and cause the change to take effect. These changes will not be retained
across a power cycle unless a Save configuration is performed.
• Click Secondary IP Address to proceed to the Secondary IP Address configuration page.
• Click Delete to delete the selected Virtual Router. Note that the router cannot be deleted if there are secondary
addresses configured.
• Click Track Interface to proceed to the VRRP Track Interface configuration page.
• Click Track Route to proceed to the VRRP Track Route configuration page.

Configuring a Secondary VRRP Address

To configure a secondary VRRP address, first configure one IP address (the primary address) for the VR. Then, you can
add multiple secondary addresses to that interface.
• Click Submit to apply the new configuration and cause the change to take effect. These changes will not be retained
across a power cycle unless a Save configuration is performed.
• Click Delete to delete the selected secondary IP address.
• Click Cancel to return to the Virtual Router Configuration page.

Creating a New Virtual Router

1 From the Virtual Router Configuration page, select Create from the VRID and Slot/Port menu.
2 Specify the VRID, the virtual router address, and the interface for the new virtual router.
3 Define the remaining fields as needed.
4 Click Create to apply the changes to the system.
The new virtual router is saved, and the device is updated.

Modifying a Virtual Router

To modify the settings for an existing virtual router, select its ID from the VRID and Slot/Port menu and change the fields as
needed. Click Submit to apply the changes to the system.
Page 314 Virtual Router Redundancy Protocol (VRRP)
Table 197: Virtual Router Configuration Fields (Cont.)
Description
Enter the IP Address associated with the Virtual Router. The default is 0.0.0.0, which
you must change prior to clicking Create.
Select the type of Authentication for the Virtual Router from the dropdown menu. The
default is None. The choices are:
• 0-None: No authentication is performed.
• 1-Simple: Authentication is performed using a text password.
If you selected simple authentication, enter the password.
Select active or inactive from the dropdown menu to start or stop the operation of the
Virtual Router. The default is inactive.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09