Appendix A: Configuration Examples; Configuring Vlans; Figure 375: Vlan Example Network Diagram - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
A pp e n di x A : C o nfi g ur a t io n E x a m p l e s
This appendix contains examples of how to configure selected features available in the D-Link Unified Access System
software. Each example contains procedures on how to configure the feature by using the Web interface, CLI, and SNMP.
This appendix describes how to perform the following procedures:
•

Configuring VLANs

• Configuring VLAN Routing
• Configuring Multiple Spanning Tree Protocol
• Configuring 802.1X Network Access Control
• Configuring a Virtual Access Point
• Configuring Differentiated Services for VoIP
Each configuration example starts from a factory-default configuration unless otherwise noted.
C VLAN
ONFIGURING
The diagram in this section shows a switch with four ports configured to handle the traffic for two VLANs. Port 0/2 handles
traffic for both VLANs, while port 0/1 is a member of VLAN 2 only, and ports 0/3 and 0/4 are members of VLAN 3 only.
The following examples show how to create VLANs, assign ports to the VLANs, and assign a VLAN as the default VLAN to
a port.
Document 34CSFP6XXUWS-SWUM100-D7
S

Figure 375: VLAN Example Network Diagram

D-Link Unified Access System
Configuring VLANs Page 539