Brother HL-2600CN Service Manual page 140

Code No.
CHECK WASTE TONER PACK
14-3
14 CHECK WASTE
MISPRINT
15
15 MISPRINT
16-1
ALIGN FU.UNIT
16 ALIGN
16-2 ALIGN FUSER CL ROLLER
16 ALIGN FUSER
LCD Message
TONER PACK[*4]
[*6] [*4]
FU.UNIT [*4]
CL ROLLER [*4]
V-15
Description of Message
x
The engine is idling.
x
The Power LED is lit.
x
Replace the waste toner pack with a
new one.
x
This message will be automatically
cleared by open & close operation of
the paper exit cover taking place while
replacement of the waste toner pack.
The message is cleared also by
pressing the - button.
x
The engine is idling.
x
The Power LED is lit.
[*6] The type of misprint will be indicated
as follows;
NOPQR: No PRREQ-N signal is
available.
PAPER: No paper is available in
the feeder while executing the print
operation after receipt of the print
command.
MEDIA: While executing the print
process after receipt of print
command, the media type of feeder
is not consistent with the specified
media type.
Misprint occurred while the Duplex
printing.
x
This message can be cleared by
pressing the - button.
x
The engine is standstill.
x
The Power LED is lit.
x
The fusing unit is not installed.
Reconfirm the installation status of the
fusing unit.
x
This message will be automatically
cleared by open & close operation of
the paper exit cover. The message is
cleared also by pressing the - button.
x
The engine is idling.
x
The Power LED is lit.
x
The cleaning roller is not installed.
Reconfirm the installation status of the
cleaning roller.
x
This message will be automatically
cleared by opening & closing the
paper exit cover. The message can
also be cleared by pressing the -
button.