Brother HL-2600CN Service Manual page 185

<Replacing Procedure>
1) Remove the OPC belt cartridge.
2) Cover the belt cartridge with the protective sheet and place the belt cartridge on
the flat surface.
Waste toner feeder
Charger unit
3) Open the green hooks at the right and left hand sides.
4) Remove the charge unit from the OPC belt cartridge.
Charger unit
5) Clean the area where the charge unit is mounted.
6) Install the new charge unit onto the OPC belt cartridge.
7) Close the hooks at both sides to hold the charge unit.
There remains the waste toner in the OPC belt cartridge. Take care not to spill toner
due to any shock or vibration.
Protective sheet
Fig.6-10
Hook
Fig.6-11
CAUTION
VI-14