Brother HL-2600CN Service Manual page 276

5) Remove the set screw BT4X10 (1 pc.) to remove the TR3 rear band from the transfer
unit 2.
6) Remove the set screws BT3X8 (4 pcs.) to remove the transfer unit 2 cover 2 from the
transfer unit 2.
Transfer unit 2
Transfer unit cover 2
Note:
When assembling the transfer unit cover 2 onto the transfer unit 2, push the (lever) of the
transfer unit 2 and put the lever on the back side of the transfer unit 2 into the square
hole on the transfer unit cover 2.
Fig.7-90
VII-64
TR3 rear band