Brother HL-2600CN Service Manual page 247

4.3.3 Base Cover (L) 2
1) Remove the set screws TS4X8 (2 pcs.) from the base cover (L) 2.
2) Remove the base cover (L) 2 from the base.
Note:
If the optional lower tray unit is fitted, it will be necessary to remove the lower tray clamp
screw and locking bar to release the base cover (R). For further information, refer to the
User Guide.
N
When re-assembling the base cover, insert the leading edge of the base cover (L) 2
into the hook provided at the bottom (left and right) of the base plate.
N
Ensure that the projecting part (
base plate bottom.
Fig.7-51
PRECAUTION 
) of the base cover (L) 2 goes into the hole in the
VII-35
Base cover (L) 2