iv) Is there anything under the printer, or is there something stuck to the printer
base?
5)
After checking these items, initialize the printer again (opening/closing the top
cover automatically initializes the OPC belt cartridge), and measure the gap on the
OPC belt cartridge again.
If the gap is in the range of 5 ± 2 mm, the printer is installed correctly. (Refer to the
figure for Step 3).)
6)
If the gap is NOT in the range of 5 ± 2 mm, follow the steps below;
i) When the gap is more than 7 mm;
(the OPC belt has moved to the
right.)
Place something 1 cm thick such as
a book under the right hand side of
the printer as shown in the figure on
the right.
Initialize the printer again and then
measure the gap on the OPC belt
cartridge. If the gap is in the range of
5 ± 2 mm, the printer is installed
correctly.
Printer base
A-37
Book
Metal frame