Brother HL-2600CN Service Manual page 206

4) Clean the area where the drum cleaner 2 is mounted.
5) Install a new drum cleaner 2 to the printer.
Align both ends of the drum cleaner 2 to the bearings in the printer and push the
drum cleaner 2 into the printer.
When installing the drum cleaner 2, be sure to put it into the printer correctly,
indicated by a click.
Sequence of Assembling
1) Install the drum cleaner cover.
2) Close the paper exit unit cover 2.
3) Plug the power code into the printer, and turn on the printer.
4) Upon completion of the warming-up process.
5) Press any of the Menu buttons (+, -, Set or Back) to take the printer Off Line.
6) Press + or – until "RESET MENU" appears.
7) Press Set to proceed to the next menu level, and then press + or – until "PARTS
LIFE" appears.
8) Press Set, and then press + until "120K KIT" appears.
9) Press Set, and then press Go. The printer is now in the READY state.
Spring
Fig.6-30
CAUTION
VI-34
Shaft of drum cleaner 2
Shaft of counter