Fusing Unit Replacement - Brother HL-2600CN Service Manual

2.2 Fusing Unit Replacement

<Criterion of Replacement>
The fusing unit should be replaced with a new one according to the periodical
maintenance cycle set out in Table 6-4.
When the time is due for replacement of the fusing unit, the following message
appears on the control panel. (The display is blinked.)
REPLACE FUSER
<Purpose of Replacement>
To prevent the print quality from declining due to the deterioration of the fixing unit's
fuser rollers.
WARNING
The fusing unit and its surrounding area are very hot. Make sure prior to starting the
replacement work that the fusing unit and its surrounding area are well cooled down,
otherwise you may get burned.
<Necessary Tools and Replacement Materials>
1) Two or three pieces of cotton cloth for cleaning
2) Fusing Unit (one unit)
VI-23