2.8 Transfer Drum 2 Replacement
<Criterion of Replacement>
The transfer drum 2 should be replaced with a new one according to the periodical
maintenance cycle set out in the Table 6-4.
When time is due for replacement of the transfer drum 2, the following message
appears on the control panel. (The display is blinked.)
It should be also replaced when an image failure occurs due to transfer drum 2
damage.
<Work Procedure>
1) Whenever an image failure occurs, confirm the cause by following the
information in Section 5 of Chapter VIII.
2) If the image failure still occurs, replace the transfer drum 2 referring to Section
4.1.12 of Chapter VII.
Transfer drum 2
N
This is one of the periodic replacement items, not customer service. It should be
implemented upon request of the customer or at periodic maintenance.
N
After replacement, confirm the improvement of print quality failure by test printing.
REPLACE 120K KIT
Fig.6-33
CAUTION
VI-37