Fusing Unit - Brother HL-2600CN Service Manual

4.7

Fusing Unit

N
The fuser unit consists of important safety parts.
Replacement of parts or disassembly and maintenance work should only be done at
an appropriate service facility by skilled service personnel acquainted with electrical
safety. After re-assembly the product safety should be reconfirmed.
N
Since the fuser unit is very hot, make sure that the fuser unit and surrounding area
are well cooled down prior to starting the replacement of parts. You may get burned
when touching hot areas.
N
The fusing unit contains silicone oil. Take care not to spill the silicone oil, especially
on the floor, as the floor will become very slippery and dangerous.
1) Remove the set screw ST3X6 (1 pc.) to remove the fuser cover (R) from the fusing
unit.
2) Remove the set screw ST3X6 (1 pc.) to remove the fuser cover (L) from the fusing
unit.
3) Remove the set screws ST3X6 (2 pcs.) to remove the fuser cover B from the fusing
unit.
4) Remove the set screws ST3X6 (3 pcs.) to remove the BR felt ASSY 2 from the
fusing unit.
5) Remove the set screws (2 pcs.) to remove the fu paper guide from the fusing unit.
Fuser cover (L)
[Note in Parts Replacement]
Fu paper guide
Fusing unit
Fig.7-97
VII-68

DANGER
Fuser cover (B)
BR felt ASSY 2
Fuser cover (R)