Brother HL-2600CN Service Manual page 282

13) Remove the set screws ST3X6 (3pcs.). Open the fusing unit as shown in the figure
below.
14) Remove the back-up roller 2 from the fusing unit.
15) Remove the C ring from the gear to remove the gear (FU) (BR) 2.
16) Remove the ball bearing FU2 (2 pcs.) from the back-up roller 2.
Back-up roller 2
Ball bearing FU2
Fig.7-100
Ball bearing FU2
Fig.7-101
VII-70
Fusing unit
C ring
Gear (FU) (BR) 2