Paper Pick-Up Roller And Separator Pad 2 Replacement - Brother HL-2600CN Service Manual

2.7 Paper Pick-up Roller and Separator Pad 2 Replacement

<Criterion of Replacement>
The paper pick-up roller and separator pad 2 should be replaced with new ones
according to the periodical maintenance cycle set out in Table 6-4.
When time is due for replacement of the paper pick-up roller and separator pad 2,
the following message appears on the control panel. (The display is blinked.)
They also should be replaced when paper feed jams occur.
<Work Procedure>
1) Whenever paper feed jams occur, confirm the cause by following the information
in Section 3 of Chapter VIII.
2) If the paper jam still occurs, replace the paper pick-up roller and separator pad 2
referring to Section 4.6.6 of Chapter VII.
N
This is one of the periodic replacement items, not customer service. It should be
implemented upon request of the customer or at periodic maintenance.
N
After replacement, confirm the improvement of feeding for the normal paper,
transparency, thick paper, etc.
REPLACE 120K KIT
Paper pick-up roller
Fig.6-32
CAUTION
VI-36
Separator pad 2