Relays Expansion Board 4581 - Panasonic MEW01 351 Planning Manual

Panasonic Electric Works Nordic AB
MEW01351 Rev: -
6.2.2.4
6.2.2.5
6.2.2.6
6.2.2.7
6.3
6.4
Planning Instructions Fire alarm system EBL512 G3, V1.1.x
and low voltage states cannot be reached / activated. After alarm reset
(in EBL512 G3) the zone line input will return to the normal state.
Short-circuit state
The short-circuit current limit
the zone line. This normally generates a fault condition in EBL512
G3 but instead a fire alarm can be activated, if this option is selected
via WinG3.
Open circuit state
The open circuit current limit
zone line current consumption, i.e. the end-of-line device is not
detected. This generates a fault condition in EBL512 G3. From this
state any other state can be reached / activated.
Disconnected state
Via menu H8/S1 (Disconnect loop / zone line input) the zone line
input can be disconnected
From this state no other state can be reached / activated.
Low voltage state

8 relays expansion board 4581

Each board has to be programmed via WinG3 regarding:

Address / Board no. (set via the jumpers "JP2-JP4", see Figure 5,
page 27.
The 4581 board has eight programmable relay outputs (Output 0-7).
Connections to "J1:1-16" and "J2" according to drawing 512 G3 - 34.
Each output has to be programmed via WinG3 regarding:

Type of output, i.e. output for Control, Alarm devices, etc.

Output signal period (steady, pulse, delay, etc.)

Logic, i.e. normally open (NO) or normally closed (NC)
15
contacts

Control expression (one or more trigger conditions)
For more information, see
"Programmable outputs", page 68.
The terminals support a wire size up to 1.13 mm
Inputs and outputs expansion board 4583
Each board has to be programmed via WinG3 regarding:

Address / Board no. (set via the jumpers "JP2-JP4", see Figure 5,
page 27.
14
This is indicated in EBL512 G3 by the LED Fault / Disablements
"General disablements".
15
Relay contact ratings: Max. 2A @ 30 V DC.
13
is exceeded, indicating short-circuit on
13
is passed, indicating no or too low
14
, i.e. there is no voltage on the zone line.
the WinG3 help and chapter
2
29
(1.2 mm).