Programmable Outputs - Panasonic MEW01 351 Planning Manual

Panasonic Electric Works Nordic AB
MEW01351 Rev: -
12
Planning Instructions Fire alarm system EBL512 G3, V1.1.x

Programmable outputs

In each control unit are four programmable voltage outputs (S0-S3)
and two programmable relay outputs (R0-R1) available. 8 relays
expansion boards (4581) and Input and Output expansion board
(4583) with three programmable outputs (Output 0-2) can be mounted
in each EBL512 G3. See chapter "Expansion boards 458x", page 26.
On the COM loops can be connected Addressable Multipurpose I/O
units (3361) with two programmable relay outputs (Re0-Re1) per unit
and Addressable 2 voltage outputs units (3364). Addressable siren
(3377) and Addressable sounder base (3379) can also be connected on
the COM loops, i.e. the units have no physical outputs, only the siren
and sounder respectively.
Each voltage output is programmed (WinG3), when applicable,
regarding:

Name (Normally not changed)

Type

Logic (Normally low / high)

Supervised / Not Supervised

Output signal period (Activation - time, delay, pulse, etc.)

Control expression
Figure 11. WinG3 Control unit "Voltage Output" dialog box.
68