Alarm Devices (Addressable Sounders) - Panasonic MEW01 351 Planning Manual

Panasonic Electric Works Nordic AB
MEW01351 Rev: -
9.1.3
Planning Instructions Fire alarm system EBL512 G3, V1.1.x
technical address can be written.
The Address setting tool (3314) is also used for mode setting:
NORMAL mode: Used for 3364 in system EBL512 G3.
2330 mode: Not used in system EBL512 G3.
2312 mode: Not used in system EBL512 G3.
NOTE! See also chapter "Limitations", page 160.

Alarm devices (addressable sounders)

3377 Addressable siren. The siren is connected to a COM loop. It is
power supplied via the COM loop, i.e. the number of sirens is
depending on the type and number of other units connected to
37
the COM loop.
(tones) and three priority levels are available. For each level an
output control expression and a sound type is programmed (via
WinG3). For more technical data, see the Product Leaflet.
The COM loop address is set with the Address setting tool
(3314).
The Address setting tool (3314) is also used for mode setting:
NORMAL mode: Used for 3377 in system EBL512 G3.
2330 mode: Not used in system EBL512 G3.
2312 mode: Not used in system EBL512 G3.
NOTE! See also chapter "Limitations", page 160.
3379 Addressable sounder base.
(3312) mounted together with a sounder. 3379 is mounted in
the ceiling. An analog detector can be plugged in the base,
which has screw terminals for the COM loop and an ext. LED
(2218). Prepared for mechanical lock of the detector - if
required. Recess for label holder (3391).
supplied via the COM loop, i.e. the number of sounder bases is
depending on the type and number of other units connected to
37
the COM loop . Three sound types (tones) and three priority
levels are available. For each level an output control expression
and a sound type is programmed (via WinG3).
technical data, see the Product Leaflet.
The COM loop address is set with the Address setting tool
(3314). The unit has an address label on which the programmed
COM loop address can be written. (The detector has its own
COM loop address set via the Address setting tool 3314.)
The Address setting tool 3314 is also used for mode setting:
NORMAL mode: Used for 3379 in system EBL512 G3.
2330 mode: Not used in system EBL512 G3.
2312 mode: Not used in system EBL512 G3.
NOTE! See also chapter "Limitations", page 160.
4380 Addressable beacon.
loop. It is power supplied via the COM loop, i.e. the number of
beacons is depending on the type and number of other units
37
The number of 3377 + 3379 units must be < 50.
38
This unit has replaced the Sounder base 3378.
Red ABS plastic housing. Three sound types
38
3379 consists of an analog base
40
The LED beacon is connected to a COM
48
3379 is power
For more