Panasonic MEW01 351 Planning Manual page 7

Panasonic Electric Works Nordic AB
MEW01351 Rev: - Planning Instructions Fire alarm system EBL512 G3, V1.1.x
16.22 Test of routing equipment ________________________ 110
16.23 Calibration of supervised outputs __________________ 110
16.24 Service signal _________________________________ 110
16.25 Fault signal (fault condition) ______________________ 111
16.26 Alarm texts ___________________________________ 111
16.26.1 Creating the alarm texts via WinG3 ____________ 111
16.26.2 Downloading alarm texts to the DU:s 1728 / 1735 /
1736 and ext. FBP:s 1826 / 1828 ________________________ 113
16.27 Real time clock (RTC) __________________________ 113
16.27.1 Daylight saving time ________________________ 114
16.28 Loss of main power source _______________________ 114
16.29 Evacuate _____________________________________ 114
16.30 WinG3 menu Tools _____________________________ 115
17 Special New Zealand functions ______________ 117
17.1 Alarm devices ___________________________________ 117
17.1.1 Silence alarm devices (inside switch) _____________ 117
17.1.2 New Zealand FB Silence switch (outside switch) ____ 117
17.2 Battery faults ____________________________________ 119
17.2.1 FAULT: Battery _____________________________ 119
17.2.2 FAULT: Low battery capacity __________________ 119
17.3 Watchdog reset __________________________________ 119
17.4 Routing equipment isolate (disable) __________________ 119
17.5 Acknowledged alarm _____________________________ 119
18 Cyber sensor functions _____________________ 121
Pulse up - down counter ___________________________ 122
18.1
Pulse up - down counter for smoke ______________ 122
18.1.1
Pulse up - down counter for temperature __________ 122
18.1.2
Pulse up - down counter for smoke & temperature __ 122
18.1.3
18.2 Fire judgement __________________________________ 122
18.3 Alarm threshold levels ____________________________ 123
18.4 Learning function / Learning conditions _______________ 123
18.4.1 Learning conditions ___________________________ 123
18.5 Alarm delay time _________________________________ 125
18.6 Analog data output _______________________________ 126
18.7 Sensitivity compensation __________________________ 126
18.8 Self diagnosis of internal devices ____________________ 127
18.9 Address setting check _____________________________ 127
19 Control unit properties ____________________ 128
19.1 Control unit properties dialog box ___________________ 128
19.1.1 General Information __________________________ 128
19.1.2 Peripherals __________________________________ 128
19.1.3 Misc. ______________________________________ 128
19.2 WinG3 Control unit pop-up menu ___________________ 129
19.2.1 Reset alarm counter ___________________________ 129
19.2.2 Software version _____________________________ 129
5