Panasonic LightPix AE20 User Manual page 101

Checking measurement data
When carrying out measurement in RUN mode, you can check the minimum and maximum of the detected
length in the X and Y directions. When setting the direction of the inspection object in CONFITURATION
mode to X, you can check the default or previous settings by selecting Y, but you should not refer to the
settings.
Display
data
switch
Product
type
switch
*Data range
Unit type
ANE2000
Data
X 0 to 2.00
Y 0 to1.60
*The view range changes within the range of 70 x 56 to 100 x 80 depending on the installation position of
ANE2030, but the position data are converted into mm based on the range of view 80 x 70. Therefore, if you
use the unit out of the view range 80 x 70, the position data differs from the actual size.
94
Upper line: Product type number and data type
Data type: MinX / MaxX / MinY / MaxY
•
MinX: Minimum in the X direction
•
MaxX: Maximum in the X direction
•
MinY: Minimum in the Y direction
•
MaxY: Maximum in the Y direction
•
Time: Calculation time
Lower line: Data value
•
Detection length: Up to four digits* including the
numbers under the decimal point
The unit failed to detect any length, the display on
the display is as the figure shown right
•
Calculation time: Up to two digits* including the
numbers under the decimal point
If the detection direction is set to either X or Y, the
measurement data for unselected direction are not
displayed.
ANE2010 ANE2020
0 to 10.00 0 to 30.00
0 to 8.00 0 to 25.00
The <3>, <4> and <5> buttons:
Change the product types
Once you switch the product types,
the outputs to the ports of OUT1 to
OUT3 are reset.
ANE2030*
0 to 80.00
0 to 70.00