Setting Procedure And Modes - Panasonic LightPix AE20 User Manual

4.5.2 Setting Procedure and Modes

Inspection is performed following the steps below:
1 Set up devices.
2 Turn the LightPixAE20 on.
Configure the
3 LightPixAE20
(in CONFIGURATION mode)
Run a teaching
4
(In TEACHING mode)
Set judgement criteria
5
(In JUDGEMENT CRITERIA
SETTING)
Execute an inspection
6
(In RUN / RUNVIEW mode)
There are mainly four modes available for the LightPixAE20. The settings that you can make vary depending
on the mode. To switch the modes, follow the instructions below.
72
Install the main unit, and connect to a power supply unit,
each unit and external devices.
Apply 24 V DC.
Set up the LightPixAE20 system in CONFIGURATION
mode. Hardware settings of the unit, output method of
reading data, saving method of captured images and other
inspection conditions.
In the TEACHING mode, register a distance between the left
upper of the point in the inspection area and the detected
point, set the exposure time or range for measuring area
(inspection area), and area for setting extraction color.
In JUDGEMENT CRITERIA SETTING mode, set the
allowable distance limit between the left upper inspection
area of the point and the point.
Press the TRIGGER button in RUN (RUN VIEW) mode.
Section 3
-
Page 73
Page 75
Page 79
Page 80