Panasonic LightPix AE20 User Manual page 73

TEACH: OKNG (Teaching for OK and NG products)
In INSPECTION (or RUN)
mode
If the ALARM signal is output after teaching is completed, the signal is held ON until teaching is
successfully completed. As long as the unit keeps outputting the ALARM signal, it cannot properly
execute an inspection.
66
TEACHING mode ("TEACH" is displayed.)
Upper line- Binary level: 0 – 255
(default: 150)
<3>: Decreases the value
<4>: Increases the value
Lower line-Exposure time: 0.03 to
50.00 ms (default: 1.93)
<7>: Shortens the exposure time
<8>: Extends the exposure time
If you want to perform a teaching at this
point, press <6> first and then <1>.
SIZE: Resizes the inspection area
If you want to execute a teaching at this
point, press <6> first and then <1> after
resizing.
MOVE: Moves inspection area
<6>: Executes a teaching for the
current product type
Teaching for the current product type is
executed.
STNG: Teaching for OK
products-Normal completion
FAIL: Abnormal termination of
teaching
→The ALARM signal is output.
<6>: Executes a teaching
Executes a teaching for NG product of
the current product type
DONE: Teaching for NG
product-Normal completion
FAIL: Abnormal teaching
(the ALARM signal is output.)
<5>: Returns to the top.
You can always
switch the product
types by pressing
<2> and <5> buttons
at the same time.