Setting Procedure And Modes - Panasonic LightPix AE20 User Manual

4.3.2 Setting Procedure and Modes

Make the inspection settings following the steps below:
1 Set up devices.
Turn the LightPixAE20
2
on.
Configure the
LightPixAE20
3
(in CONFIGURATION
mode)
Run a teaching
4
(in TEACHING mode)
Set judgement criteria
5
(in JUDGEMENT
CRITERIA SETTING mode)
Execute an inspection
6
(in RUN / RUNVIEW
There are mainly four modes available for the LightPixAE20. The settings that you can make vary depending
on the mode. To switch the modes, follow the instructions below.
48
Install the main unit, and connect to a power supply unit, each
unit and external devices.
Apply 24 V DC.
Set up the LightPixAE20 system in CONFIGURATION mode.
Hardware settings of the unit, output method of reading data,
saving method of captured images and other inspection
conditions.
In the TEACHING mode, register extraction color and
template (base) image, at the same time, set the exposure
time or range for measuring area (inspection area), and area
for setting extraction color.
In JUDGEMENT CRITERIA SETTING mode, set the limits of
area values (min. to max.). and the threshold value of degree
of similarity for detected image.
Press the TRIGGER button in RUN (RUN VIEW) mode.
mode)
Section 3
-
Page 49
Page 52
Page 56
Page 57