Table of Contents
Advertisement
4.3.5 Setting Judgement Criteria in JUDGEMENT CRITERIA SETTING Mode
Based on the X-and Y-directional distance between the left upper corner of the inspection area that saved by
teaching and the center of the template, set the allowable limit for OK judgement in mm. If the image is
located within the range from the left upper corner of the inspection area to the median between the detection
positions of the OK product and NG product when an OK/NG teaching was executed, change the limit in this
mode as necessary. Set the degree of similarity of the detected image in this mode, too.
Operation in JUDGEMENT CRITERIA SETTING mode
The number in < > in the table below represents the button number of the
operation unit (see the figure on the right).
In INSPECTION (or RUN)
mode
56
In JUDGEMENT CRITERIA SETTING mode ("SET" is displayed)
Top line: Product type number and current allowable
limit*
Bottom line: X, allowable limit to be set
Sets the X-directional allowable limit
Top line: Product type number and current allowable
limit*
Bottom line: Y, allowable limit to be set
Sets the Y-directional allowable limit
Top line: Product type number, the degree of similarity
during a test run in TEACHING mode
Bottom line: M, the degree of similarity to be set
Advertisement
Table of Contents
