Table of Contents
Advertisement
2.2.2 Texts Displayed on the LCD Monitor of the Operation Unit
The display area of the operation unit displays measurement data and setting values and operating status of
the LightPixAE20 as a text string.
Displayed
Mode
text
SET
CONFIGURATION mode
RUN
RUN (RUN VIEW) mode
TEACH
TEACHING mode
VIEW
RUN VIEW mode
READY
RUN (RUN VIEW) mode
TEACHING mode
LOCK
RUN (VIEW) mode
ALARM
RUN (VIEW) mode
(Red)
TEACHING mode
(May be displayed when the
device is in the other
modes.)
OUT1-3
RUN (RUN VIEW) mode
mm
RUN (RUN VIEW) mode
2
mm
RUN (RUN VIEW) mode
8
Description
Indicates the LightPixAE20 is in CONFIGURATION mode
Indicates the LightPixAE20 is in RUN mode.
Indicates the LightPixAE20 is in TEACHING mode.
Indicates the LightPixAE20 is RUNVIEW mode. In this mode,
captured images are displayed on the finder unit.
Displayed when parallel output signal "READY" is ON.
Means the lock function is activated. In this mode, you cannot
operate the LightPixAE20.
Displayed when the parallel output signal "ALARM" is ON.
Represents output state of parallel output signals OUT1-3. The
signals that are turned on are displayed.
For example,
•
OUT 1 2: OUT1 and OUT2 signals are on.
Indicates the unit for the measured data is millimeter. You can
check it only if you are using the following applications:
•
Color Pattern Matching
•
Edge
•
Peak
•
Measurement
Indicates the unit for the measured data is square millimeter.
You can check it only if you are using the following applications:
•
Color Area
•
Color Judgement
Advertisement
Table of Contents
