Panasonic LightPix AE20 User Manual page 65

Checking the measured data
When inspecting in RUN mode, you can confirm X- and Y- directional positions, degree of similarity and
inspection time.
Display
data
switch
Back to Top
Product
type
switch
*Range of position data
Type
ANE2000
Data
X 0 to 2.00
Y 0 to 1.60
*The view range changes within the range of 70 x 56 to 100 x 80 depending on the installation position of
ANE2030, but the position data are converted into mm based on the range of view 80 x 70. Therefore, if you
use the unit out of the view range 80 x 70, the position data differs from the actual size.
58
Upper line: Product type number and data type
Data type: X / Y / Time / M
•
X: X-directional position
•
Y: Y-directional position
•
Time: Computation time
•
M: The degree of similarity
Lower line: Data value
•
Position: Up to four digits* (including the numbers
under the decimal point)
•
Computation time; Up to two digits (including the
numbers under decimal point
•
Degree of similarity: 0 - 100
When the unit failed to detect an image having more than
the degree of similarity, the screen display is as the figure
shown right.
ANE2010 ANE2020
0 to 10.00 0 to 30.00
0 to 8.00 0 to 25.00
The <3>, <4> and <5> buttons:
Changes the product types
Once the product types are switched,
OUT1 to 3 are reset
ANE2030*
0 to 80.00
0 to 70.00