•
ALARM signal
When the unit failed to complete a teaching, the ALARM signal is displayed or output after
executing a teaching. In this case, follow the instructions below:
-Freeze the object while executing a teaching
-Reset the exposure time manually
•
If you change to RUN mode before executing a teaching for NG product, the ALARM signal is
output. The ALARM signal is held ON until teachings for OK and NG products are successfully
completed. As long as the unit keeps outputting the ALARM signal, it cannot execute an
inspection properly.
Resizing and positioning the inspection and color extraction areas
Resizing the inspection and color extraction areas
Moving the inspection and color extraction areas
You can resize these three types of area
following the common way. The figure on the
left is an example inspection area.
Area
Display
Inspection
SIZE
Color
T.SIZE
extraction
Template
M.SIZE
X direction (wide)
•
The <3> button : Reduces the width
•
The <4> button: Enlarges the width
Y direction (length)
•
The <7> button: Reduces the length
•
The <8> button: Enlarges the length
You can move these three types of area
following the common way. The figure on the
left is an example template area.
Area
Display
Inspection
MOVE
Color
T.MOVE
extraction
Template
M.MOVE
•
The <3> button: Moves the area to
the left
•
The <4> button: Moves the area to
the right
•
The <8> button: Moves the area up
•
The <7> button: Moves the area
down
Area color
Blue
Black
Pink
Area color
Blue
Black
Pink
55