Panasonic FP-D250 User Manual page 474

Departmental counter mode
1. Setting up the user access codes
1) Activate the departmental mode by F5-42.
2) Input a 3 digit key operator access code in the
F7-01.
3) Exit the service mode.
4) Press the User Preset key and select General
function.
5) Proceed to next page and select code "09".
6) Input a 3 digit key operator access code.
7) Select code "14" and press Departmental counter mode.
8) Select "Password".
9) Allocate a separate access code for each authorized
operator, then press the Start key after each entry.
2. Clear the meter reading of departmental counter
1) Perform the above procedures 4) through 7).
2) Select the required departmental counter.
3) Input "0" to clear the counter.
4) Press the Start key after each entry.
3. Setting up the limit copy number for each departmental counter
1) Perform the above procedures 4) through 7).
2) Select the required departmental counter.
3) Input the maximum total number of copies that each
operator is allowed to make.
4) Press the Start key after each entry.
5-36