Panasonic FP-D250 User Manual page 550

Location
4
1
5
1
6
1
7
Note: Refer to Operating Guide 'Chapter 2: Installing the Network Adapter Card'
before turning on the power switch.
6-24
Procedure
(1) Install the Riser card PCB onto
the system control PCB.
(2) Reinstall the system control PCB.
(3) Install the NAC PCB onto the riser
card PCB.
(1) Install the mounting screws.
(2 screws)
Perform following procedures only
when the printer controller is in-
stalled.
(1) Connect the NAC harness to the
connector J10 of the NAC PCB
and J2 of the printer controller
PCB.
(1) Reinstall the rear cover.
(2) Install the wire clamp.
(Except for north America)
Check