(2) Installation procedure
Remove all shipping materials before installation.
Caution: Make sure the copier is unplugged before the installation.
Location
1
2
3
4
2
6-26
Shipping material/Procedure
(1) Remove the copier rear cover.
(7 screws)
(1) Remove the hard disk mounting
bracket. (right) (2 screws)
1
(1) Install the printer hard disk
1
drive.(4 screws)
(1) Connect the IDE signal harnesses
1
to the IDE connector on the hard
disk drive and the printer control
PCB.
(2) Connect the power supply har-
ness to the hard disk drive.
(3) Reinstall the hard disk drive
mounting bracket (right).
3
(4) Reinstall the rear cover.
Check