Panasonic FP-D250 User Manual page 85

Cleaning position
1 Sheet bypass paper
transfer roller
2 Sheet bypass paper
feed roller
3 Registration roller
4 Middle roller
5 Paper feed roller
6 Pick up roller
7 Cleaning sheet
8 Corona wire
9 Corona grid / Corona
case
10 Lower developer frame
Dust cover
11 Transport belt
12 Transfer corona wire /
Corona case/
Transfer guide plate
13 Fuser guide plate
14 Fuser thermister
15 Fuser separation finger Cloth
(upper/lower)
16 Fuser heat roller /
pressure roller
3-12
Tool/solvent Work/precaution
- Use IPA, if toner is stuck on the
Cloth with
rollers. (use sparingly)
water / IPA
- Do not use cotton for cleaning
Brush / IPA - Remove paper dust by brushing
it.
Cloth with - If not replaced at PM cycle, high
water voltage leak may occur.
- Insure that the wire does not sag and
is not kinked.
- Do not use cotton for cleaning.
- Lift the developer unit (mag-roll
Brush /
side) up 45°, and rotate mag-roller
Vacuum
knob 4~5 times counterclockwise.
cleaner /
Remove the toner dust on lower
Cloth with
developer frame by brush or
water
vacuum cleaner.
- Clean the lower developer frame
with cloth.
Cloth with - Use damp cloth.
water
Cloth
Cloth
- Remove toner dust on separation
fingers.
- Don't damage separation finger
edges.
Cloth
- Use IPA, if the rollers are very
dirty.
(to be continued)