Changing The Settings; Setting Method - Toshiba GRE110 Instruction Manual

4.2.6 Changing the Settings

The "Set. (change)" sub-menu is used to make or change settings for the following items:
Password
Description
Relay address and IP address
Baud rate in IEC60870-103 or Modbus
IEC 61850 setting
Recording setting
Status setting
Protection setting
Binary input setting
Binary output setting
LED setting
Control setting
Frequency setting
All of the above settings except the password can be seen using the "Set. (view)" sub-menu.
CAUTION
Modification of settings :
"scheme switch" and "protection element" in the "Protection" menu. Dependencies exist between
the settings in the various menus, with settings in one menu becoming active (or inactive) depending
on the selection made in another menu. Therefore, it is recommended that all necessary settings
changes be made while the circuit breaker tripping circuit is disconnected.
Alternatively, if it is necessary to make settings changes with the tripping circuit active, then it is
recommended to enter the new settings into a different settings group, and then change the "active
group" setting, thus ensuring that all new settings become valid simultaneously.
4.2.6.1

Setting Method

There are three setting methods as follows:
- To enter a selected item
- To enter a text string
- To enter numerical values
To enter a selected item
If a screen as shown below is displayed, perform setting as follows.
The cursor can be moved to upper or lower lines within the screen by pressing the ▲ and ▼ keys.
If setting (change) is not required, skip the line with the ▲ and ▼ keys.
Care should be taken when modifying settings for "active group",
 101 
6 F 2 T 0 1 7 2