Selection Of Output Relay; Setting The Logic Gate Type And Timer - Toshiba GRE110 Instruction Manual

Selection of output relay

•
Select "Binary O/P" on the "Set. (change)" screen to display the "Binary O/P" screen.
/ 2 B i n a r
> B O 1
B O 2
B O 3
B O 4
B O 5
B O 6
B O 7
B O 8
Note: The setting is required for all the binary outputs. If any of the binary outputs are not used, enter
0 to logic gates #1 to #4 in assigning signals.
• Select the output relay number (BO number) and press the ENTER key to display the "BO∗"
screen.
/ 3
> L o
F u n c

Setting the logic gate type and timer

• Select "Logic/Reset" to display the "Logic/Reset" screen.
/ 4
L o
> L o
O R /
R e
I
• Enter 0(=OR) or 1(=AND) to use an OR gate or AND gate and press the ENTER key.
• Enter 0(=Instantaneous) or 1(=Delayed) or 2(=Dwell) or 3(=Latched) to select the reset timing
and press the ENTER key.
• Press the END key to return to the "BO∗" screen.
Note: To release the latch state, push the [RESET] key for more than 3 seconds on a digest screen.
y O / P
Available for model 402 and 422.
Available for model 402 and 422.
Available for model 402 and 422.
Available for model 402 and 422.
B O ∗
g i c / R e s e
t i o n s
L o g i c / R e s
g i c
g i c
A N D
s e t
n s / D I / D w /
 139 
t
e t
_
0
0
L a t
6 F 2 T 0 1 7 2