Status; Setting The Metering; Setting The Time Synchronisation - Toshiba GRE110 Instruction Manual

4.2.6.6

Status

To set the status display described in Section 4.2.4, do the following:
Select "Status" on the "Set. (change)" sub-menu to display the "Status" screen.
/ 2
> M e
T i
T i

Setting the metering

• Select "Metering" to display the "Metering" screen.
/ 3
D i
> D i
P r
• Enter 0 or 1 or 2 and press the ENTER key.
Enter 0(=Pri) to display the primary side current in kilo-amperes(kA).
Enter 1(=Sec) to display the secondary side current.
Enter 2(=Pri-A) to display the primary side current in amperes(A).

Setting the time synchronisation

The calendar clock can run locally or be synchronised with the binary input signal or Modbus or
IEC103 or SNTP. This is selected by setting as follows.
• Select "Time sync." to display the "Time sync" screen.
/ 3
T i
> T i
O f
S N T P
• Enter 0, 1, 2, 3 or 4 and press the ENTER key.
Enter 0(=off) not to be synchronised with any external signals.
Enter 1(=BI) to be synchronised with the binary input signal.
Enter 2(=Mod) to be synchronised with the Modbus.
Enter 3(=103) to be synchronised with the IEC103.
Enter 4(=SNTP) to be synchronised with the SNTP.
S t a t u s
t e r i n g
m e s y n c .
m e z o n e
M e t e r i n g
s p l a y
s p l a y
i / S e c / P r
T i m e s y n c
m e s y n c .
m e s y n c .
f / B I / M o d /
 114 
This setting is displayed if submodel of
communication type is A-D.
_
1
i - A
.
_
1
1 0 3 /
6 F 2 T 0 1 7 2