Toshiba GRE110 Instruction Manual page 142

/ 3
> L E D 1
L E D 2
L E D 3
L E D 4
L E D 5
L E D 6
C B
Note: The setting is required for all the LEDs. If any of the LEDs are not used, enter 0 to logic gates
#1 to #4 in assigning signals.
• Select the LED number and press the ENTER key to display the "LED∗" screen.
/ 4
> L o
F u n c
L E D
Setting the logic gate type and timer
• Select "Logic/Reset" to display the "Logic/Reset" screen.
/ 5
L o
> L o
O R /
R e
I
• Enter 0(=OR) or 1(=AND) to use an OR gate or AND gate and press the ENTER key.
• Enter 0(=Instantaneous) or 1(=Latched) to select the reset timing and press the ENTER key.
• Press the END key to return to the "LED∗" screen.
Note: To release the latch state, push the [RESET] key for more than 3 seconds.
L E D
C L O S E D
L E D ∗
g i c / R e s e
t i o n s
C o l o r
L o g i c / R e
g i c
g i c
A N D
s e t
n s t / L a t c h
 141 
t
s e t
_
0
0
6 F 2 T 0 1 7 2